That said, they will be tweaking the settings, so what works today might be different from later. ![]() It cuts and engraves beautifully, if a little drab and dull in the grey material category! For example, 0.095 chipboard from Fancy Feast catfood boxes. I know that materials can vary among the various samples you are attempting to laser, but I hope to have done the heavy lifting by then and you can have a narrow window to test out on the particular samples you have. Perhaps by the time you have your Glowforge I’ll have tested and charted a bunch of non-ProofGrade for your convenience. In my laser’s software I can specify the RGB values so I could do thousands but the difference between 200/210/210 (RGB) and 200/210/220 is hard to see visually Otherwise you’ve got 100 colors in your stack to assign power/speed settings to and can’t tell which one is which ![]() Not sure how you’ll do that in the GF.) By making the box color and setting the parameters right away you don’t lose track of similar colors. (In my laser software it shows a color/operation stack on the right and as I add colors to the design they pop up in the stack. Then color each box’s outline and set the power/speed right then. ![]() So when you set it up, make them all black strokes. But you’ll end up with a ton of colors with shades that are going to be close to each other. You don’t need a fill (at least on other machines) as the engrave of the stroke color will engrave everything inside the boundary of that color’s box. So you need a file with about some different colored boxes for the stroke and then make the fill black.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |